If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Cylinder Wrenches for 0-320A Narrow Deck
Hi, I'm looking for the 12 point serrated drivers used on the cylinder nuts
of an 0-320A Narrow Deck. I checked out the Autmotive Parts shops in my local town but they only had them available in metric sizes, not the 1/2 " and 3/8 " (I Think) needed. I have a set of Lycoming cylinder wrenches for convensional nuts, as used on my 0-290d, and wanted to adapt them. Any Ideas out there?? Dave. |
#2
|
|||
|
|||
Actually a 6 pointed allen wrench will work. They make a cylinder base
wrench that has a 6 point hex on the end for these internal wrenching nuts. Try your local EAA chapter tool library or an older A&P as they were very popular in the 50s. -- Cy Galley, TC - Chair, Emergency Aircraft Repair, Oshkosh Editor, EAA Safety Programs or Always looking for articles for the Experimenter "DAVE" wrote in message ... Hi, I'm looking for the 12 point serrated drivers used on the cylinder nuts of an 0-320A Narrow Deck. I checked out the Autmotive Parts shops in my local town but they only had them available in metric sizes, not the 1/2 " and 3/8 " (I Think) needed. I have a set of Lycoming cylinder wrenches for convensional nuts, as used on my 0-290d, and wanted to adapt them. Any Ideas out there?? Dave. |
Thread Tools | |
Display Modes | |
|
|