If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
Lord Engine Mounts
Well I ended up finding the answer to this question. The determining
factor in the size/type of Lord Mount you use has very little to do with the engine of choice as many different rubber mounts can be used for the same size engine. It all comes down to the width of the "cup" on your dynafocal ring. For instance the ring that is being used to make the mount for my O-235 L2C has cups/attachment points that are 2.75" wide. These take Lord Mount # J-7402-5 and they sell at Aircraft Spruce for $239 for the set of four. I haven't checked pricing elsewhere yet. Don. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centurion FAQ with kibbitzing | Bret Ludwig | Home Built | 0 | November 12th 05 10:39 PM |
Gyrocopter Speed | Mark | Rotorcraft | 36 | August 16th 05 11:28 PM |
ROP masking of engine problems | Roger Long | Owning | 4 | September 27th 04 07:36 PM |
What if the germans... | Charles Gray | Military Aviation | 119 | January 26th 04 11:20 PM |
Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |