|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 27th 10, 06:13 PM
posted to rec.aviation.soaring
|
|||
|
|||
Hexcel Hexweb Source
I was looking for a couple small pieces of hexcel aluminum honeycomb.
I want it for "airflow directionalization" project. Want the thermals to start flowing upward only ;-) Hexweb CR III or similar material Either 2 pieces of 4”x7” minimum or a single piece 7x7” min. I think any of these products would work approxmately .600" thick. 1/8’, 5/32” or 3/16” cell 5052 or 5056 alloy Any foil thickness. Does anyone have a source? Thanks Chris 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone got a source... | Jay Honeck[_2_] | Home Built | 12 | November 17th 09 01:47 AM |
| New Lift Source | Tony Condon[_2_] | Soaring | 1 | May 22nd 09 12:55 AM |
| The one source for SEO Services | r2e8t02p | Home Built | 0 | December 5th 07 10:33 AM |
| Cortec source | KEITH B SHOAPS | Home Built | 0 | August 16th 04 10:51 PM |
| Online source for POH | Jim | Owning | 3 | July 1st 03 06:56 PM |
Threaded Mode