If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
"Sid Knox" wrote:
Yes, that's a good plan except in my case I cannot "...Just tape them over the inlets and fly." because if one gets free it will go thru the prop! However (as seen in the photo), there is a series of top cowling screws that I can use to secure a temporary scoop. Hmm. I guess I should've read the whole thread before I made my prevous posting. It merely proves the "PMTA" rule: paranoid minds think alike. :-) Russell Kent |
#22
|
|||
|
|||
I don't know what engine size you have, but I have a Franklin 220hp
in my SQ2000 canard and the scoops do quite well in keeping the engine cool. http://www.abri.com/sq2000/finish21.jpg (sidk) wrote in message . com... ..... Yes, that's a good plan except in my case I cannot "...Just tape them over the inlets and fly." because if one gets free it will go thru the prop! However (as seen in the photo), there is a series of top cowling screws that I can use to secure a temporary scoop. Sid |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Testing Stick Ribs | Bob Hoover | Home Built | 3 | October 3rd 04 02:30 AM |
Pressure testing gone bad | Mark Hickey | Home Built | 17 | November 25th 03 02:29 AM |
Looking for out of service main rotor blades for testing newro... | James Lloyd | Home Built | 0 | July 28th 03 10:27 PM |
Looking for out of service main rotor blades for testing new rotor | Wright1902Glider | Home Built | 9 | July 28th 03 06:06 AM |
Torsional Vibration Testing | B2431 | Home Built | 8 | July 25th 03 07:15 AM |