If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Do a Google search for RST Engineering.
Jim Weir wrote an article for KITPLANES awhile back on this subject. He has archived those articles on his website. |
#2
|
|||
|
|||
"john smith" wrote in message ... Do a Google search for RST Engineering. Jim Weir wrote an article for KITPLANES awhile back on this subject. He has archived those articles on his website. Hi and thanks for the reply. I looked at Jim Weir's site and didn't see an answer to my specific question, but I'll take another look. Thanks, Dennis Johnson |
#3
|
|||
|
|||
I remember him sayin a laser disc would work fine. If yer plane is
composit it could be inside if metal no need and wood and fabric probably just under the fabric but i'm not so sure on that! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | September 1st 04 07:27 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | February 1st 04 07:27 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | January 1st 04 06:27 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | December 1st 03 06:27 AM |
A Good Story | Badwater Bill | Home Built | 15 | September 3rd 03 03:00 PM |