If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rigging a Cherokee 6-300
My maintenance shop rigged my control surfaces, at my request. The
plane 'seemed' to have been flying in a bank, despite having the AI centered and DG on the same track. They found that the flaps were the biggest culprits and adjusted them accordingly. When I flew it and took it up to cruise, the plane flew straight without that 'banking' feeling. But, my rudder trim continues to be pretty far right. With the rudder trim indicator in the middle, I have to apply a lot of right rudder. Is this normal, or should I get it to the point that I can have the rudder trim centered. On the ground with the front wheel straight and the rudder trim in neutral, the rudder is dead center, too. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CHEROKEE NATIONAL FLY-IN - MORE INFORMATION | Don | General Aviation | 0 | June 16th 04 05:13 AM |
Cherokee National Fly-In & Convention - THIS MONTH | Don | General Aviation | 0 | June 3rd 04 05:01 AM |
Cherokee National Fly-In & Convention | Don | General Aviation | 0 | May 5th 04 08:12 PM |
Cherokee National Fly-In & Convention | Don | General Aviation | 0 | March 20th 04 02:15 AM |
Cherokee National Fly-In and Convention | Don | General Aviation | 0 | January 26th 04 04:25 AM |