If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
[quote=shkdriver;721144](big snip)
Prestec products, Hey, Also for what it's worth, It probably goes without saying, Work Closely with your A&P IA, and the maker of your aircraft concerning methods and products. During my project I was told about a guy who Repaired a Dart and could not get it inspected because of the adhesive he used. OOps! Scott W. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sanding of plywood before epoxy | [email protected] | Home Built | 6 | July 15th 08 01:21 PM |
Sanding or Waxing - PIK 20 Question | culverflyer | Soaring | 22 | September 22nd 05 09:01 PM |
Advice on sanding fibreglass | [email protected] | Home Built | 12 | April 28th 05 10:39 PM |
Sanding composites | [email protected] | Home Built | 12 | January 31st 05 06:47 AM |
Fear of Sanding | Stuart Grant | Soaring | 7 | January 17th 05 05:28 PM |