If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
I saw a Trailer cover offered. Seems to cover quite nicely a standard Cobra trailer. Color is white.
I wonder if this a solution to reduce or eliminate formation of condensation inside the trailer walls, especially metal ones. I would assume that since the top and side walls are somewhat insulated they will cool down slow enough at night so that dew will not form on them. What do you guys think ? Dan |
#2
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
We have no clue......where are you?
What works in one geographic area may be poor in another. So......where are you?!?! Moon or Mars, you are likely OK.....on earth, may be good, may suck...... |
#3
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
|
#4
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
On Saturday, January 26, 2019 at 2:11:59 PM UTC-5, Charlie M. (UH & 002 owner/pilot) wrote:
We have no clue......where are you? What works in one geographic area may be poor in another. So......where are you?!?! Moon or Mars, you are likely OK.....on earth, may be good, may suck...... I am located in Northeast of USA |
#5
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
Condensation may happen as a result of one of these two causes:
* the trailer is full of warm humid air (from a hazy humid summer day in the NE US) and then cools off at night to below the dewpoint of that air. A cover won't help with that at all. * on a not-humid summer night in the NE US, the air in the trailer may not quite cool down to its dewpoint, but under a clear sky the trailer roof (especially if metal) cools further by radiation, causing condensation both above (not an issue) and below (inside the trailer). A cover may help with this - but only if it is thick enough to have a significant insulating effect. |
#6
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
On Saturday, January 26, 2019 at 11:04:02 PM UTC-5, wrote:
Condensation may happen as a result of one of these two causes: * the trailer is full of warm humid air (from a hazy humid summer day in the NE US) and then cools off at night to below the dewpoint of that air. A cover won't help with that at all. * on a not-humid summer night in the NE US, the air in the trailer may not quite cool down to its dewpoint, but under a clear sky the trailer roof (especially if metal) cools further by radiation, causing condensation both above (not an issue) and below (inside the trailer). A cover may help with this - but only if it is thick enough to have a significant insulating effect. I have an Avionic trailer. With the factory solar fan, air is exchanged, cooler (drier) air enters before dark and condensation is not a problem. |
#7
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
I thought those trailer covers were more to protect trailer GRP surface finish against UV and water degradation than to prevent internal condensation.
|
#8
|
|||
|
|||
Trailer Covers-will that eliminate condensation inside ?
On Sun, 27 Jan 2019 07:10:38 -0800, jpg797 wrote:
I thought those trailer covers were more to protect trailer GRP surface finish against UV and water degradation than to prevent internal condensation. Several years ago a clubmate had similar condensation problems with a metal-skinned box trailer (I think this is what's called a 'tube trailer' in the US). He lined it with 3mm (1/8") white polystyrene foam sheet[*] held in place with contact glue and said it fixed his condensation problems, though IIRC he didn't enjoy applying the glue in the confined space inside the trailer. I'd think the same solution should work for a Cobra and, because you're pretty much in free air with the top up, the contact adhesive fumes should be much less problematic. [*] in the UK this is used as an interior wall liner. It comes in 500mm x 10m (5 sq.m, 53 sq.ft) rolls at around $5 a roll. -- Martin | martin at Gregorie | gregorie dot org |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CAPA Trailer Covers | [email protected] | Soaring | 3 | February 8th 15 07:12 AM |
Foam for inside of fiberglass trailer | John[_27_] | Soaring | 9 | April 4th 13 04:12 AM |
condensation INSIDE of glider parts | Brad[_2_] | Soaring | 2 | January 12th 11 07:04 PM |
Condensation in hangar | karl gruber[_1_] | Owning | 7 | September 19th 07 03:48 PM |