|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 19th 03, 02:11 AM
|
|||
|
|||
TrueType N number Font?
I have a vinyl cutter that will do the 12" letters called for to do N
numbers but wonder if there is a TrueType font that meets the specifications of the FAA. That is 12" high, width 2/3 of height, thickness 1/6 of height etc. Any suggestions gratefully relieved! Errol Groff Instructor, Machine Tool Department H.H. Ellis Tech 613 Upper Maple Street Danielson, CT 06239 860 774 8511 x1811 http://pages.cthome.net/errol.groff/ http://newenglandmodelengineeringsociety.org/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pitts Number 1 registration number | Mirco | Aerobatics | 3 | December 4th 04 11:50 AM |
| Phone number for Dillsberg? | Robert Bonomi | Home Built | 2 | September 9th 03 11:17 PM |
Threaded Mode