If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Here is a small (30 KB) gif picture of the drill speed table from the above mentioned tool catalog. I'll leave it up for just a few days. http://www.AirplaneZone.com/Newsgrou...ill-Speeds.gif Great info, but it says no permission to access that page. Ed Wischmeyer |
#22
|
|||
|
|||
"Ed Wischmeyer" wrote in message ... Here is a small (30 KB) gif picture of the drill speed table from the above mentioned tool catalog. I'll leave it up for just a few days. http://www.AirplaneZone.com/Newsgrou...ill-Speeds.gif Great info, but it says no permission to access that page. Ed Wischmeyer Worked for me. OE 6.0 -- Jim in NC |
#23
|
|||
|
|||
"Ed Wischmeyer" wrote in message
... Here is a small (30 KB) gif picture of the drill speed table from the above mentioned tool catalog. I'll leave it up for just a few days. http://www.AirplaneZone.com/Newsgrou...ill-Speeds.gif Great info, but it says no permission to access that page. That's just for you, Ed. Works good for me! ;o) Rich S. |
#24
|
|||
|
|||
Ed Wischmeyer wrote: http://www.AirplaneZone.com/Newsgrou...ill-Speeds.gif Great info, but it says no permission to access that page. The file should be accessible to all by using the full url. However, the directory listing is not accessible. I could email the file to if you continue to have access problems. If anyone else has access problems, please let me know. Thanks, David O -- http://www.AirplaneZone.com |
#25
|
|||
|
|||
On Mon, 24 Nov 2003 05:08:49 -0500, David O
wrote: Ed Wischmeyer wrote: http://www.AirplaneZone.com/Newsgrou...ill-Speeds.gif Great info, but it says no permission to access that page. The file should be accessible to all by using the full url. However, the directory listing is not accessible. I could email the file to if you continue to have access problems. If anyone else has access problems, please let me know. Thanks for the information. Over the years I have developed a 'feel" for the speeds, but it's nice to see them in print so I know if I've been doing it right or not. :-)) No problem dowloading the GIF. You'll have to fix the return add due to dumb virus checkers, not spam Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair?) www.rogerhalstead.com Thanks, David O -- http://www.AirplaneZone.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
Tool Question??? | Paul | Home Built | 2 | September 1st 03 04:06 PM |
Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 06:03 AM |
Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 12:18 AM |