If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Of course, only empirical testing will provide an answer WRT the PIK20D,
however, positive results were achieved in the Dick Johnson Ventus 2 flight test. See part 2 http://www.ssa.org/Johnson/80-1996-06.pdf Good sealing generally yields good results. Frank Whiteley "culverflyer" wrote in message ... With the S seals would there be an advantage to have the external Mylar's? "Chris" wrote in message . au... "S" seals are possible and I've replaced them in a PIK, just make the seals long enough to allow side movement when refitting to hinge pins, probably do not require "S" seals if Mylar's are fitted top and bottom Chris Runeckles Universal Plastics P/L "Janos Bauer" wrote in message ... Chuck Lohre wrote: Internal seals seemed impossible because the ailerons and flaps have to move side ways to assemble. Hmm, it should be possible somehow since our pik was factory installed with it. /Janos |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mylar seals installation | John W | Soaring | 2 | May 5th 04 09:03 PM |
mylar seals wing to flap/ Aileron | culverflyer | Soaring | 2 | May 5th 04 02:52 PM |
ZZ Mylar seals | Mike | Soaring | 3 | March 29th 04 03:45 PM |
mylar seals | D.A.L | Soaring | 1 | February 23rd 04 07:15 PM |
Mylar tape wing seals - effect on wing performance | Simon Waddell | Soaring | 8 | January 1st 04 03:46 PM |