If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
LS-3A Parts Needed
Our club is in need of LS-3A fuselage control parts. We have a damaged LS-3A fuselage for a rebuild project that was damaged in a hurricane. Sad news is that several fuselage parts were removed and lost. If there is a LS-3A fuselage out there please let me know. Bob, Treasure Coast Soaring Club
|
#2
|
|||
|
|||
LS-3A Parts Needed
We made one out of two, a few years back.........believe we still have most cockpit controls, some gear parts, etc Email me exact requirements and I’ll take a look in the barn. ............any/all for the cost of shipping!
JJ |
#3
|
|||
|
|||
LS-3A Parts Needed
On Wednesday, December 18, 2019 at 3:37:12 PM UTC-6, wrote:
We made one out of two, a few years back.........believe we still have most cockpit controls, some gear parts, etc Email me exact requirements and I’ll take a look in the barn. ............any/all for the cost of shipping! JJ When you go to the barn, JJ, mind looking for any LS6 cockpit parts you might have? Steve Leonard |
#4
|
|||
|
|||
LS-3A Parts Needed
On Wednesday, December 18, 2019 at 1:37:12 PM UTC-8, wrote:
We made one out of two, a few years back... I remember that ship. As I recall, it has a horizontal stabilizer you spliced together out of two right halves, since it turned out that the section is symmetrical. Or maybe left halves. --Bob K. |
#5
|
|||
|
|||
LS-3A Parts Needed
On Wednesday, December 18, 2019 at 4:37:12 PM UTC-5, wrote:
We made one out of two, a few years back.........believe we still have most cockpit controls, some gear parts, etc Email me exact requirements and I’ll take a look in the barn. ............any/all for the cost of shipping! JJ Thank you very much, I will get the bird out of the trailer and take a look at what is missing and then list what we need. After the hurricane damage someone took several components out of the cockpit and they are not to be found, any assistance is greatly appreciated. Bob |
#6
|
|||
|
|||
LS-3A Parts Needed
There is an LS-4 up for salvage bid here in Phoenix. Are any of these parts useful to you?
Boggs |
#7
|
|||
|
|||
LS-3A Parts Needed
After an accident people assume the ship is totaled and are capable of doing some incredibly stupid things. We got a Cirrus that someone had hack-sawed the aileron push-rod into, right next to quick release fitting! Then there was the G-103 that ground-looped which bent the aft carry-through bar, this put the wing attach fittings in a bind and the wings wouldn’t come off! Club members used a pry-bar on the release fittings...................that little bit of stupidity really did total the bird!
JJ |
#8
|
|||
|
|||
LS-3A Parts Needed
On Thursday, December 19, 2019 at 9:33:40 AM UTC-5, wrote:
After an accident people assume the ship is totaled and are capable of doing some incredibly stupid things. We got a Cirrus that someone had hack-sawed the aileron push-rod into, right next to quick release fitting! Then there was the G-103 that ground-looped which bent the aft carry-through bar, this put the wing attach fittings in a bind and the wings wouldn’t come off! Club members used a pry-bar on the release fittings...................that little bit of stupidity really did total the bird! JJ We bought a 1-26 that was declared a total loss because the salvage guys, there to collect a Blanik, tried to drill the main pins out of the 1-26 that was next to it! They were not even at the right ship. You can not think this stuff up. UH |
#9
|
|||
|
|||
LS-3A Parts Needed
On Thursday, December 19, 2019 at 8:08:43 AM UTC-6, Waveguru wrote:
There is an LS-4 up for salvage bid here in Phoenix. Are any of these parts useful to you? Boggs Looks like that salvage yard also has a Discus... Steve Leonard |
#10
|
|||
|
|||
LS-3A Parts Needed
On Thursday, December 19, 2019 at 7:26:35 AM UTC-5, Bob Youngblood wrote:
On Wednesday, December 18, 2019 at 4:37:12 PM UTC-5, wrote: We made one out of two, a few years back.........believe we still have most cockpit controls, some gear parts, etc Email me exact requirements and I’ll take a look in the barn. ............any/all for the cost of shipping! JJ Thank you very much, I will get the bird out of the trailer and take a look at what is missing and then list what we need. After the hurricane damage someone took several components out of the cockpit and they are not to be found, any assistance is greatly appreciated. Bob We do need a rudder, a canopy would be nice and the control linkages that connect to the stick. I have had some replies, and thank you very much. We want to get this bird in great condition again for our youth program. Bob |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RV-3 Kit/Parts Needed | Deb | Home Built | 2 | May 28th 09 02:26 AM |
Pik-20 Parts needed | WAVEGURU | Soaring | 1 | October 23rd 07 11:39 PM |
Schweizer 1-34 Parts Needed | Ken Sorenson | Soaring | 0 | May 8th 06 06:29 PM |
USA: ASK-21 parts needed | Pete Brown | Soaring | 0 | June 16th 05 06:26 AM |
Parts Needed | Jim Phoenix | Soaring | 0 | September 17th 03 03:27 AM |