|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 11th 18, 07:45 AM
posted to rec.aviation.soaring
|
|||
|
|||
Refinishing Ventus b Fuselage
Richard,
How did you determine to use the aft wing locating pin bearings for mounting on your rotisserie? I'm just at that stage in building one for my Ventus. 
|
|
#2
November 11th 18, 02:42 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Refinishing Ventus b Fuselage
On Saturday, November 10, 2018 at 11:45:51 PM UTC-8, Robert Seccombe wrote:
Richard, How did you determine to use the aft wing locating pin bearings for mounting on your rotisserie? I'm just at that stage in building one for my Ventus. It was narrower than the front and it make the tail lighter. You do have to adjust the tail height to rotate the fuselage. A rope to the ceiling makes this easier. Richard www.craggyaero.com
|
|
#3
November 14th 18, 12:33 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Refinishing Ventus b Fuselage
On Friday, October 12, 2018 at 9:16:35 PM UTC-4, Richard Pfiffner wrote:
Pictures and process for refinishing a ventus b fuselage. Work in progress pictures and process as work is completed. http://www.craggyaero.com/ventus.htm Richard www.craggyaero.com Nice work, looks like you are well prepared.
|
|
#4
December 24th 18, 03:51 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Refinishing Ventus b Fuselage
On Friday, October 12, 2018 at 8:16:35 PM UTC-5, Richard Pfiffner wrote:
Pictures and process for refinishing a ventus b fuselage. Work in progress pictures and process as work is completed. http://www.craggyaero.com/ventus.htm Richard www.craggyaero.com Beautiful work Richard, well done. Chris
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 12:15 AM |
| refinishing | Stig Pedersen | Soaring | 1 | November 27th 05 04:50 PM |
| refinishing | Stig Pedersen | Soaring | 1 | November 26th 05 09:16 PM |
| Second speaker in Ventus 2b/c fuselage | [email protected] | Soaring | 3 | September 14th 05 05:41 PM |
| REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |
Hybrid Mode
