|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 10th 12, 12:34 PM
posted to rec.aviation.soaring
|
|||
|
|||
Comet to Cobra Trailer fittings conversion
Folks,
One of our club members has an older Comet trailer that was semi converted with wing dollies and fittings similar to a Cobra. Any intel how this vwas accomplished or where the parts might be located? GL 
|
|
#2
November 10th 12, 07:49 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Comet to Cobra Trailer fittings conversion
Knott Ghb in Germany. They are the original supplier for Komet trailers. You will find all the part and instructions for setting the brakes. Great customer service when I needed a new damper shock. Look at the tongue for the vin tag for your specific model.
JJB
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Comet to Cobra Trailer fittings conversion | Gregg Leslie[_2_] | Soaring | 0 | November 10th 12 12:33 PM |
| Comet trailer gas struts | Phillip LaBerge | Soaring | 2 | November 20th 10 04:57 PM |
| Trailer fittings and carpetting | [email protected] | Soaring | 3 | September 4th 09 03:27 AM |
| Comet trailer near catastrophe | [email protected] | Soaring | 14 | March 16th 08 04:07 AM |
| Cobra trailer fittings for different glider makes & models | John W | Soaring | 4 | September 24th 03 03:21 PM |
Linear Mode
