|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 22nd 04, 12:16 PM
|
|||
|
|||
IPAQ Wiring - which pins are used
There are commercial solutions availabe, ready to use.
But I would like to know which pins are used on the IPAQ 3900 side for a two wire communication with the GPS and which pins are used for the +5V power supply. The IPAQ connector has some 22 pins and I guess that for power pins 19 gets +5V and pin 21 gets ground. A standard serial cable may connect pins 6,7,8,9,10,11,12,13,14, whereas the USB cable connects to what? Is it pin 17 and 22 or some of the serial pins? Can someone explain the pin usage for a 4 wire power/com cable on the IPAq side? Thanks a lot Michael 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| iPaq wiring, cradles and mounts for gliders - Ideas?? | Jim Kelly | Soaring | 12 | December 4th 03 11:45 PM |
| Commercial - iPAQ Cradles In Stock | Paul Remde | Soaring | 0 | October 29th 03 10:57 PM |
| Ipaq - GPS_Log Help needed (Long) | Steve B | Soaring | 1 | September 27th 03 06:00 AM |
| iPAQ h2210/h2215 Review | Paul Remde | Soaring | 0 | September 3rd 03 03:45 AM |
| iPaq screen viewability | Raphael Warshaw | Soaring | 7 | July 27th 03 06:02 PM |
Threaded Mode