|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
December 30th 05, 01:06 AM
posted to rec.aviation.owning,sci.electronics.design,alt.solar.photovoltaic
|
|||
|
|||
Wind/Solar Electrics ???
Your sampling of only the bandwidth information is not
complete for decoding. "Ray Andraka" wrote in message news:zIdsf.34359$Mi5.7331@dukeread07... SolarFlare wrote: The point is the sampling rate has to be done at just over double the frequency of the signal and not the bandwidth. No, that is not correct. It only needs to be sampled at 2x the bandwidth, assuming the spectrum has been properly filtered to energy outside the signal of interest. See my earlier post. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on 172 M electrics... (1974 Skyhawk II) | [email protected] | Piloting | 8 | April 10th 04 04:52 AM |
Threaded Mode