If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
SAFE Winch Launching and automatic gearboxes
Chris,
Nothing special required, except that the rollers or pulleys should be smoothed out and polished if they have been used for steel cable. Some types of drum may need to be reinforced as Dyneema can slip and tighten on the drum to the extent that it get crushed. What type of winch do you have? Derek Copeland At 23:50 22 July 2009, Chris Nicholas wrote: Has anybody in the good old US of A developed a printed, available, specification for the pay-on gear for Dyneema etc. rope =96 like low weight (aluminum? - note USA spelling!) rollers, low friction and low inertia bearings, anything special needed for the drum , etc.? I suspect that there is scope for saving inventing too many wheels twice over. (And for the avoidance of doubt, I am NOT going to get into the Bildan/ DC/DJ etc. spats =96 you are all welcome to keep those among yourselves.) Chris N. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Winch Launching in US | john hawkins | Soaring | 11 | June 10th 09 12:18 PM |
Winch Launching | Rolf | Soaring | 27 | January 7th 09 02:48 AM |
Ka8b winch launching | Jimmie L. Coulthard | Soaring | 11 | September 9th 08 08:38 AM |
Aerotow Fuel Costs & Winch Launching | Derek Copeland[_2_] | Soaring | 2 | May 26th 08 03:14 PM |
LIppmann reports a 950 meter winch launch with their Dynatec winch line - anything higher? | Bill Daniels | Soaring | 20 | December 27th 04 12:33 AM |