|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 12th 10, 12:09 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cutting 57mm holes in the instrument panel.....how to?
Here in the states I find it impossible to find metric hole saws.....so,
what have others done when cutting new panels for 57mm instruments? Thanks! J4 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WANTED: 57MM Avionic / Instrument - Stuff | Scott Alexander[_2_] | Soaring | 1 | October 25th 09 03:56 AM |
| WANTED: 57MM Avionic / Instrument - Stuff | Scott Alexander[_2_] | Soaring | 0 | October 25th 09 01:58 AM |
| DG-300 instrument panel | [email protected] | Soaring | 14 | January 29th 06 02:48 PM |
| LS 6 b instrument panel | John Brenann | Soaring | 4 | November 19th 05 04:37 AM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 01:19 AM |
Threaded Mode