|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 10th 05, 09:47 PM
|
|||
|
|||
LS3 flaperon gap seal template needed
Does anyone have a template or detailed instructions to make and apply
the gap seal between flaperon and fuselage which many have told me I should have on my LS3? 
|
|
#2
May 10th 05, 11:02 PM
|
|||
|
|||
|
I have one somewhere... I will find it and email it to you.
Regards, Larry Goddard "01" USA "Birdbones" wrote in message : Does anyone have a template or detailed instructions to make and apply the gap seal between flaperon and fuselage which many have told me I should have on my LS3?
|
|
#3
May 14th 05, 12:46 AM
|
|||
|
|||
|
I have placed the templates on my website:
http://goddard.com/soaring/flapwiper/ Good soaring! Larry Goddard "01" USA "01-- Zero One" wrote in message : I have one somewhere... I will find it and email it to you. Regards, Larry Goddard "01" USA "Birdbones" wrote in message : Does anyone have a template or detailed instructions to make and apply the gap seal between flaperon and fuselage which many have told me I should have on my LS3?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| builder assistance needed | AINut | Home Built | 0 | April 8th 05 07:05 AM |
| Water dump valve rotary seal | Bill Daniels | Soaring | 6 | May 10th 04 11:02 AM |
| Remove oil seal from vacuum pump adapter on Lycoming IO320 HOW????? | Ron | Home Built | 2 | February 24th 04 04:34 PM |
| Weatherstripping | Hankal | Owning | 3 | November 29th 03 01:09 AM |
| Crank Seal? | Mark S Conway | Owning | 3 | November 10th 03 04:29 AM |
Linear Mode
