Colibri Ipaq problem!

I had a similar problem with my Palm. Im my case was a matter of speed.
Instead of 19200, try 9600 or 4800.

I can't understand why, but the fact is it works well like this.

JB


wrote in message
oups.com...
I just installed a colibri and IpAQ system.
I'm running a ipaq 5550 w/ SeeYou Mobile
The colibri "knows" where it is(shows correct long/lat and altitude)
but when I turn the ipaq on, the colibri beeps and the lcd says "19200
connect "

At the same time SeeYou says "no GPS Data"
However "Connect Me" recognizes colibri

Has anyone had this problem?
How do you fix it?

Thanks


Devin Bargainnier

I'm not sure but suspect that file transfer could take longer in this
case. (but maybe it will use another setting for pc connection).

/Jancsika

wrote:
keithw wrote:

Adjust the Baud rate from 19,200 to a lower setting , some units only
respond at 4800 .


--
keithw



Thanks that did it!

what are the disadvantages of the lower baud rate setting if any?

Thanks

Devin Bargainnier