If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gear problem in an Aztec PA23-250
I was flying around in a '64 Aztec yesterday, and did some touch and goes,
and on one downwind, dropped the gear, and did not get a right main gear down indicator light. I tried switching lightbulbs, etc. I had full hydraulics, as the flaps worked fine. I tried cycling the gear a few times, then tried pumping manually. I then flew around fairly slow in the practice area and did a few turns, and then the gear light popped on. Just prior to that, did a few flyby's at the airport, and the observer said it looked like the gear was down. Anyways, with three green, I went in and landed uneventfully. Any ideas? Bob Borucki |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Would you cycle the gear? | Roy Smith | General Aviation | 41 | April 23rd 04 10:41 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |