If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
Transponder antenna - blade vs stub monopole
At 1,000 MHz, RG-58 has a loss of about 15 db per 100 feet. So, a 10 foot
run would represent 1.5 db. That is an acceptable loss. It will reduce the range a bit. Generally, if the control cables are not resonant and not in the same plane as the antenna (horixontal controls, vertical antenna), there should be minimal interference. There are a number of antenna plotting programs arund that would allow you to plot the potential interference. to determine the possible interference. Colin Lamb |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transponder Antenna | Rick Fuller | Soaring | 6 | January 30th 08 06:03 PM |
VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 04:29 PM |
Oil on transponder antenna | Bob | Owning | 12 | May 9th 04 08:59 PM |
Transponder and antenna | Paolo | Soaring | 1 | March 6th 04 03:32 AM |
Blade type VHF antenna? | JFLEISC | Home Built | 6 | December 13th 03 04:28 AM |