If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
12 to 24v up-converter
I am trying to build the Jim Weir/Kitplanes June-06 "Quick and Dirty 12 - 24
Up-Converter." 1. Can D101 and Q101share the same heat sink electrically or must they be isolated? 2. I can not locate a "resistor form." Can R101 be wound around a dowel or other object and installed like a coil with an air core? Thanks, Charlie Willwerth |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
KLN to Garmin 396 Converter | Mike Granby | Owning | 7 | February 5th 06 01:48 PM |
FA: 12V to 24V DC voltage converter | Karl Geng, N1DL | Home Built | 2 | April 21st 05 08:48 PM |
AC to DC Converter for APU | Newps | Owning | 8 | November 30th 04 03:41 PM |
24/12 volt DC converter | Victor J. Osborne, Jr. | Products | 1 | February 18th 04 02:11 PM |
Radio Shack 140W DC-to-AC Power Converter - Simple Plug-in | MKB | Owning | 4 | August 4th 03 04:08 PM |