Looking for brush/trim for flap/spoiler handle slots

My original brush-like trim that 'covers' the slots inside the cockpit of my
LS-6 are worn down and I'd like to replace them.

Anyone know of a source for these "brushes"?

They're black nylon, about 3/4 inch wide, and serve to close the slots the
controls exit from, yet still allow their unobstructed movement.

Appreciate any leads.

John Bojack J4

Earlier, John wrote:

My original brush-like trim that
'covers' the slots inside the cockpit
of my LS-6 are worn down and
I'd like to replace them.

The stuff is called 'strip brush' or 'channel back
brush' and is available from a variety of industrial
supply outlets. Of course, finding exact replacements
can be problematic, especially if you don't want to
buy a 100-foot reel of the stuff.

One place to start is the McMaster-Carr catalog. A
search shows several strip brush products. Unfortunately,
none are 3/4' wide:

www.mcmaster.com

A typical manufacturer of the stuff is:

http://www.precisionbrush.com

I hope that helps some.

Thanks, and best regards to all

Bob K.
http://www.hpaircraft.com

Thank You,

McMaster-Carr had them.... although the bristles are 1" wide.... I'll just
cut them down to the 1/2" wide size.

J4
"John" wrote in message
ink.net...
My original brush-like trim that 'covers' the slots inside the cockpit of
my
LS-6 are worn down and I'd like to replace them.

Anyone know of a source for these "brushes"?

They're black nylon, about 3/4 inch wide, and serve to close the slots
the
controls exit from, yet still allow their unobstructed movement.

Appreciate any leads.

John Bojack J4