|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
April 6th 04, 08:07 PM
|
|||
|
|||
Thanks!
Hopefully a little oil will keep the replacement lasting a little longer too. Mike Z "Jim Weir" wrote in message ... I personally prefer cotanger material for the early 172 hinges. Cut it about 1" longer than the hinge, bend the top ½" over at about a 10° angle, insert it into the hinge, and then bend the bottom ½° at the same angle Jim Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What's Wrong with Economics and how can it be Fixed | What's Wrong with Economics and how can it be Fixe | Naval Aviation | 5 | August 21st 04 12:50 AM |
| What's Wrong with Economics and how can it be Fixed | What's Wrong with Economics and how can it be Fixe | Military Aviation | 3 | August 21st 04 12:40 AM |
| ATC says wrong position | Greg Esres | Instrument Flight Rules | 28 | April 30th 04 05:37 PM |
| Were the Tuskeegee Airmen Wrong? | Stephen Harding | Military Aviation | 63 | February 14th 04 07:38 PM |
| Wrong Brothers Air Force Party Invite | Jay Honeck | Home Built | 1 | July 20th 03 10:55 PM |
Threaded Mode