RIVETS

To All:

I buy most of my rivets (and sheetmetal too) as new-surplus from a
variety of outlets here in southern California.

Recently, rivets seem to be more available than previously; good news
when you can pick up AN470-AD4-7's for a dollar a pound.

In at least one case the rivets were declared surplus after the
subcontractor installed stir-welding equipment, allowing them to bid on
contracts for components which specify that type of fabrication.

One instance isn't enough to indicate a general trend and I'm sure
rivets will always be with us, but as prime contractors specify other
forms of component fabriction it could mean the end of low-cost
new-surplus rivets for homebuilders.

In prowling the aerospace outlets, if you see any A, B, or AD rivets in
diameters most suitable for lightplanes (typically 3/16 or smaller) I
suggest you buy some. Even if you aren't scratch-building an aluminum
airplane, someone in your Chapter is. Or will be.

-R.S.Hoover

On 27 Aug 2005 10:28:57 -0700, wrote:

To All:

I buy most of my rivets (and sheetmetal too) as new-surplus from a
variety of outlets here in southern California.

Recently, rivets seem to be more available than previously; good news
when you can pick up AN470-AD4-7's for a dollar a pound.

In at least one case the rivets were declared surplus after the
subcontractor installed stir-welding equipment, allowing them to bid on
contracts for components which specify that type of fabrication.

One instance isn't enough to indicate a general trend and I'm sure
rivets will always be with us, but as prime contractors specify other
forms of component fabriction it could mean the end of low-cost
new-surplus rivets for homebuilders.

In prowling the aerospace outlets, if you see any A, B, or AD rivets in
diameters most suitable for lightplanes (typically 3/16 or smaller) I
suggest you buy some. Even if you aren't scratch-building an aluminum
airplane, someone in your Chapter is. Or will be.

Thanks for the heads up Bob. Even the plastic G-III uses a surprising
number of rivets.

Keep those suggestions coming.

Roger Halstead (K8RI & ARRL life member)
(N833R, S# CD-2 Worlds oldest Debonair)
www.rogerhalstead.com

-R.S.Hoover

I buy most of my rivets (and sheetmetal too) as new-surplus from a
variety of outlets here in southern California.



How about some examples I'd love to find cheap rivets & sheet metal

Thanks

Paul
N1431A