|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#30
February 16th 21, 04:55 PM
posted to rec.aviation.soaring
|
|||
|
|||
USA automated panel-cutting service?
General purpose use? A small desktop hobby mill-drill weighs about 500 lbs. A small repair shop mill weighs about 2000 lbs. The lightest weight production mill starts at around 5000 lbs. That is a Mattel toy, good for paper, cardboard, soft wood, perhaps very thin aluminum if you are not in a hurry. It might chew through some thin fiberglass given time and loose tolerances, but I'd not confuse it with a general purpose use mill.
On Monday, February 15, 2021 at 7:45:04 PM UTC-8, 2G wrote: The dimensions aren't given, but you might be able to mill the panel in two passes. In any event, it's a hell of a price for general purpose use. Tom 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some LiFePO4 Battery Testing Results Manual and Automated | John DeRosa OHM Ω http://aviation.derosaweb.net | Soaring | 32 | October 20th 19 03:26 PM |
| automated flap setting | Wallace Berry[_2_] | Soaring | 16 | September 26th 16 04:03 PM |
| Cutting 57mm holes in the instrument panel.....how to? | John Bojack[_2_] | Soaring | 20 | November 12th 10 09:15 PM |
| Automated Assisted Flight System | James Long | Home Built | 2 | March 5th 06 09:58 AM |
| FAI/IGC/CAI File Name Decoding - Automated!! | ContestID67 | Soaring | 9 | September 24th 05 09:26 AM |
Threaded Mode