If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dimpling and riveting pressures
Can anybody tell me what are the typical pressures required to dimple
a skin and also to compress a flush rivet? I know that squeezer tools are rated at typically two to four tons, but what are the actual pressures required? I'm trying to work out the dimensions on a hand operated gantry for dimpling and back-riveting the skins on an RV, and I don't want to over-engineer the thing too much... Thanks, --Max |
Thread Tools | |
Display Modes | |
|
|