|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 20th 08, 09:15 PM
posted to rec.aviation.soaring
|
|||
|
|||
Prestec Repairs?
I'm looking for advice on how to repair some minor surface damage to the
Prestec finish on my LS-3? The damage consists of some scratches on the leading edges, scratches on the wing top (only through top layer of finish) and a 1/2" wide by 4" long dimple on the wing upper surface (shop rash not my own doing). Can I purchase a small amount of prestec in a can to filll in these areas and sand smooth? or is there another method? Any help appreciated Matt "RX" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prestec Repairs? | Uniform Zulu[_2_] | Soaring | 1 | October 20th 08 09:42 PM |
| Simtec/Prestec | [email protected] | Soaring | 2 | February 6th 07 08:46 PM |
| Sailplane repairs | [email protected] | Soaring | 1 | November 22nd 06 02:01 AM |
| TM6 repairs in the UK | Ian Johnston | Soaring | 2 | January 21st 06 10:26 PM |
| Canopy repairs | Jay Todd | Soaring | 2 | November 5th 03 02:44 AM |
Linear Mode
