|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 12th 05, 01:15 PM
|
|||
|
|||
Oversized bolts
Over some time the bolt holes in the link between the horizontal stabilizer
and the trim mechanism have been elongated. To get rid of the play, I consider installing an oversized bolt. The original bolt is an AN5-7. I am confused about the designation on oversized bolts. Can anyone help ? Thank you in advance. Kjell Sivertsen 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil Leak on top of the engine -- follow up | Jay Honeck | Owning | 6 | February 13th 05 01:50 PM |
| Oil leak on top of the engine | Jay Honeck | Owning | 31 | February 12th 05 02:27 AM |
| Epoxy Bonding to Aluminum and Magnesium | Ryan Young | Home Built | 25 | September 16th 04 02:45 AM |
| Source for Bolts | Dave | Home Built | 2 | May 20th 04 08:09 PM |
| Can F-15s making 9G turns with payload? | Paul J. Adam | Military Aviation | 114 | September 27th 03 05:47 AM |
Threaded Mode