|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 28th 08, 11:36 PM
posted to rec.aviation.owning
|
|||
|
|||
KX-99 antenna BNC loose
The BNC connector on the top of my KX-99 has become very slightly
loose. Does anyone know how dangerous it is to open the case up and try to tighten it? I assume it has a nut of some sort. I just don't know how much has to be removed to get to it. The radio has been great. It has worked perfectly since I bought it new maybe 15 years ago. I don't want to mess it up. Thanks Kurt 
|
|
#2
April 10th 08, 04:26 PM
posted to rec.aviation.owning
|
|||
|
|||
|
KX-99 antenna BNC loose
On Feb 28, 5:36 pm, wrote:
The BNC connector on the top of my KX-99 has become very slightly loose. Does anyone know how dangerous it is to open the case up and try to tighten it? I assume it has a nut of some sort. I just don't know how much has to be removed to get to it. The radio has been great. It has worked perfectly since I bought it new maybe 15 years ago. I don't want to mess it up. Thanks Kurt I have repaired several of these, no biggie, the nut comes loose and usually breaks the wire soldered to the connector. Al-- NM Radio Sales
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seaplane Base - 4 - Cut Him Loose-3.jpg (1/1) | john smith[_2_] | Aviation Photos | 0 | August 2nd 07 05:11 AM |
| Lycoming 0-320 Exhaust studs working loose | Mike Spera | Owning | 9 | May 26th 07 03:25 AM |
| GPS Antenna | 150flivver | Owning | 14 | December 11th 05 05:38 AM |
| ELT Antenna | Gary | Home Built | 18 | November 5th 04 02:17 AM |
| Found Loose Cylinder Bolt | Greg Hopp | Owning | 21 | February 19th 04 03:04 PM |
Linear Mode
