If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Transponders, Radios and other avionics procurement questions
I'm at the point where I need to start collecting instruments so I can
build the instrument panel. As always, I'm a bit shocked at the prices new or reconditioned instruments cost: The typical panel mount radio goes for around $900 to $1300 depending on how much power and features you want. The transponder can be around that price too. Here's another question about the transponder: Must it be coupled to an encoding altimeter or can it get it's altitude information independently of the altimeter? Or does that depend on the instrument? Speaking of the transponder, I have flown enough to have an opinion on what type of instrument is easier to operate: Those that allow you to punch in the squawk code one number after the other. The types that force you to dial in the first number, move the curser over and dial in the next etc etc do work, but it's cumbersome and adds to the work load to have to decode the instrument so you can operate it. So given the choice, I'd prefer the types that allow you to dial each of the four numbers independently, or those that allow you to punch in the number off a key pad, one after the other. For the radios, having both active and standby frequencies showing just makes good sense and lessens the workload. I've found what appears to be a pretty good source for the standard instruments in but haven't asked him yet if he also handles avionics. I'm new to this part of building so any ideas or locations or sources are welcome. Thanks, Corky Scott |
#3
|
|||
|
|||
(Corky Scott) wrote in
: .................... I am looking seriously at solid state instruments but the least expensive (Dynon) advertises that their instrument fits in a 3 and 1/8" hole. That would be ok if it were just a solid state artificial horizon, but it's more, lots more and all that extra information fits on the screen too...somewhere. Besides, it costs over $2,000 just sitting there. .... BTW the Dynon EFIS has an encoder built into it. With all the stuff it has its a real bargain at $2K. ----------------------------------------------------------------- Paul Lee ... SQ2000 canard project: www.abri.com/sq2000 |
#4
|
|||
|
|||
Hey Corky: I'm partial to going with Collins Microline when there is
space behind the panel. A tagged VHF 251 Com runs around 800$. Eastern Avionics lists a special with a VHF 251 and a VIR 351 Nav for 1200$. TDR 90 xponder for 900$. If there isn't space behind the panel , then the ProLine series with remote heads. Plus, the ProLine remote boxes have helped out a number of times with W&B problems. I haven't played with anything other than Collins, King and ARC, so I can't comment on any of the others. Craig C. |
#5
|
|||
|
|||
On Tue, 01 Jul 2003 19:01:02 GMT, Paul Lee wrote:
(Corky Scott) wrote in : .................... I am looking seriously at solid state instruments but the least expensive (Dynon) advertises that their instrument fits in a 3 and 1/8" hole. That would be ok if it were just a solid state artificial horizon, but it's more, lots more and all that extra information fits on the screen too...somewhere. Besides, it costs over $2,000 just sitting there. .... BTW the Dynon EFIS has an encoder built into it. With all the stuff it has its a real bargain at $2K. ----------------------------------------------------------------- Paul Lee ... SQ2000 canard project: www.abri.com/sq2000 Yup, it is. It has 10 instruments built into it. The only thing that detracts from it's functionality is that the screen is pretty small, less than 4 inches across. All that information from the ten instruments goes on the screen somewhere. So yes, you could buy that one instrument, plant it in the middle of your panel without anything else and have all you need for flying information. Buying each of the ten instruments would cost more than $2000. Of course, should the power supply go Tango Uniform, you've lost everything at once.... Corky Scott |
#6
|
|||
|
|||
(Corky Scott) wrote in
: On Tue, 01 Jul 2003 19:01:02 GMT, Paul Lee wrote: BTW the Dynon EFIS has an encoder built into it. With all the stuff it has its a real bargain at $2K. ... Yup, it is. It has 10 instruments built into it. The only thing that detracts from it's functionality is that the screen is pretty small, less than 4 inches across. All that information from the ten instruments goes on the screen somewhere. ......... Of course, should the power supply go Tango Uniform, you've lost everything at once.... The small size is what I need. No room on my panel for 9" TV. I have no problem reading it or following it. Just a matter getting used to it. My unit has the extra built in backup battery ($129 extra) in case the aircraft battery goes. Even with all the instruments I have some extra avionics for backup, which is a good practice in any case. But at that price, I might sell them on ebay and get a second EFIS-D10. ------------------------------------------------------------- Paul Lee .... SQ2000 canard project, www.abri.com/sq2000 |
Thread Tools | |
Display Modes | |
|
|