A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Home Built
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Remove oil seal from vacuum pump adapter on Lycoming IO320 HOW?????



 
 
Thread Tools Display Modes
  #1  
Old February 24th 04, 12:29 AM
Ron
external usenet poster
 
Posts: n/a
Default Remove oil seal from vacuum pump adapter on Lycoming IO320 HOW?????

I need to replace the oil seal (06A19956 or STD208) in the vacuum pump
adapter (61098) on my Lycoming IO320. How can I remove the existing
seal without a special Lycoming removal tool?

The oil seal is .875" ID x 1.5" OD x .3" thick.

ALL suggestions taken seriously

Thanks

  #2  
Old February 24th 04, 02:03 AM
rip
external usenet poster
 
Posts: n/a
Default

The usual way. Drive a sheet metal screw into the metal part, grab the
head of the screw with a pair of vice grips, and yank.

Ron wrote:
I need to replace the oil seal (06A19956 or STD208) in the vacuum pump
adapter (61098) on my Lycoming IO320. How can I remove the existing
seal without a special Lycoming removal tool?

The oil seal is .875" ID x 1.5" OD x .3" thick.

ALL suggestions taken seriously

Thanks


  #3  
Old February 24th 04, 05:34 PM
Jerry Wass
external usenet poster
 
Posts: n/a
Default





don't have one to look at, but if the metal back is bottomed in a recess,
and you can get access to the back side, drill a couple of 1/8" holes from
the back side, 180 deg apart & punch out , alternating between holes to keep
it straight,( as possible )

rip wrote:

The usual way. Drive a sheet metal screw into the metal part, grab the
head of the screw with a pair of vice grips, and yank.

Ron wrote:
I need to replace the oil seal (06A19956 or STD208) in the vacuum pump
adapter (61098) on my Lycoming IO320. How can I remove the existing
seal without a special Lycoming removal tool?

The oil seal is .875" ID x 1.5" OD x .3" thick.

ALL suggestions taken seriously

Thanks


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Tiny vacuum pump Jim Weir Home Built 41 January 24th 04 06:42 AM
Pumping fuel backwards through an electric fuel pump Greg Reid Home Built 15 October 7th 03 07:09 PM


All times are GMT +1. The time now is 10:16 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.