|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 31st 06, 11:07 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Carb heat. sprung hot or cold?
If a carb heat cable breaks, should the position it springs back to be
carb heat on or off? if its on you dont have full power if a go around is necessary however if youre landing and carb icing occurs you are safe if it is off you have full power but are not protected against carb icing?? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lycoming Carb Heat | Mitty | Instrument Flight Rules | 19 | September 21st 05 06:43 PM |
| Have you ever experienced carb ice with an injector carb? | flybynightkarmarepair | Home Built | 1 | January 31st 05 01:48 AM |
| Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 05:29 AM |
| Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
| alternate carb heat | Ray Toews | Home Built | 16 | October 29th 04 12:41 PM |
Linear Mode
