![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() I'm wiring some avionics that use shielded wire that needs to have the shield terminated into a connector. Is it best to solder a wire to the shield or crimp a wire to the shield so that I can put a connector pin on it? |
Thread Tools | |
Display Modes | |
|
|