If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Forming finger straps.
Orval Fairbairn wrote:
In article .com, "Mike" wrote: Orval Fairbairn wrote: In article .com, "Mike" wrote: A finger strap is a reinforcing piece of metal that is used to reinforce a joint. The impression I have is the strap is heated until it can be formed, then wrapped around both the primary and secondary tubing being joined. For both tubes the strap is formed around them. Is the strap tacked in place, then heated until it's plastic, then hammered/tapped/worked so that it is formed around the pieces, or is it somehow formed off of the tubing that's being reinforced? - Mike Tack weld, heat, hammer form when red hot, weld in place. Orval - OK, I"ll try that on some scrap; but every time the hammer touches the metal, and every place the patch touchs the base metal will tend to cool down the patch. Is there a secret? Small areas at a time? - Mike Get the strap red hot! Reheating the metal doesn't hurt it -- it relieves stresses from the forming process. Hold up, Orv. You can crystallize 4103 by getting it too hot. Get it DULLLLLLL red... Richard |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crouch Strap story | Ed Byars | Soaring | 43 | September 23rd 13 05:43 PM |
Finger Pulse Oximeter on Sale | Ray Lovinggood | Soaring | 8 | December 21st 04 03:11 AM |
Forming Company Veteran Associations | Otis Willie | Naval Aviation | 0 | August 29th 04 05:57 AM |
Forming Company Veteran Associations | Otis Willie | Military Aviation | 0 | August 29th 04 05:57 AM |
Discus Battery Straps | Brian Iten | Soaring | 6 | April 8th 04 12:20 AM |