If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
I have a 94 model that's been tied out in the North Carolina Sun for 10
years. The paint has lost much of its shine and there are some "fish eye" bubbles especially on the horizontal stabilizer, but the paint is all still intact, and it waxes up quite nicely. Nothing at all like the paint (or lack of paint) on Tony's example. That's the worst paint I have ever seen on anything. That being said, I now keep my glider in a T-hanger. If I were ordering a new L-33, I think I would order it unpainted or maybe with just the trim paint. Regards, David Walsh Jack wrote: I'm contemplating the purchase of a used Blanik L33 Solo, as an upgrade from my 1-26E, and seeking advice concerning the type. Jack |
#12
|
|||
|
|||
Well, there's nothing wrong with the L-33. It's all metal (except for
some control surfaces), so can be kept assembled and tied down (I assume this is what made the 1-26E attractive to you). It's quite docile, has reasonable performance for a metal ship, and in general is a pretty sensible ship for a club or a pilot with low total time who doesn't want to mess with assembling and disassembling after every flight and doesn't have a hangar available. The downside is - and this is of course subjective - it's not really much fun to fly. It doesn't have the light touch of the 1-26, or its ability to thermal on a fart. On the other hand, it doesn't really penetrate well either, so it's hard to consider it a serious XC machine. Sure, you can fly XC in it, and people do - but the same is true of the 1-26. I'm not sure the trade is enough of a step up to make the it worthwhile. Also, for some reason I recall thinking that your total time was pretty high. If so, and if you must have metal (I assume for assembled outside storage), I would seriously consider one of the HP's instead. Significantly better performance at less cost and all metal (no fabric) so even better for outside tiedown. Not the hot tip for someone with 50 hours total time (handling is a bit challenging) but no big deal at 500 hours. Michael |
#13
|
|||
|
|||
Michael wrote:
[The L-33 is] all metal...so can be kept assembled and tied down... and...is a pretty sensible ship for...a pilot with low total time who doesn't want to mess with assembling and disassembling after every flight and doesn't have a hangar available. I like the all-metal part, so that I can leave it out for a weekend whenever possible, but the real reason for needing to part with the wonderful 1-26E is that the wings are getting heavier with each passing year, and I can't assemble without a helper or two. This is partially a fault of the open trailer design and partially just me getting older, in addition to the design of the 1-26. I enjoy flying it, and if it unloaded, assembled, disassembled, and loaded as easily as a modern design combination, I'd stick with it indefinitely as the price cannot be beat. It's the most flying fun I've ever had for so little money, and going to any type that did not handle as well in the air would be a disappointment. Another consideration is dues, insurance, storage and operating expenses which will not change much, so the actual cost of a 50 percent performance boost is not huge. However, if I could leave the 1-26 assembled in a hangar I would not consider parting with it for the foreseeable future. ...I recall thinking that your total time was pretty high. If so, and if you must have metal...I would seriously consider one of the HP's instead. Not the hot tip for someone with 50 hours total time...but no big deal at 500 hours. Total time is ~20,000 hrs, the usual military/airline/private stuff; but, my glider time is ~35 hours (2-33 and 1-26), so I am not embarrassed being seen in low performance sailplanes. Hey, I'm still getting used to the idea of flying beyond gliding range of the glider port -- I have done it a few times when conditions were very good. Consideration is also being given to the 1-36 and the PW-5, and the PW-5 is a strong contender. If a ship is easy enough to assemble/disassemble and has an enclosed trailer, I don't mind putting it together every day of a three-day weekend. I hope to get checked out in the Club's PW-5 this season and that will aid the decision process. Either way, it's good to have a glider of my own. Jack |
#14
|
|||
|
|||
Consideration is also being given to the 1-36 and the PW-5, and the PW-5 is a strong contender. If a ship is easy enough to assemble/disassemble and has an enclosed trailer, I don't mind putting it together every day of a three-day weekend. I hope to get checked out in the Club's PW-5 this season and that will aid the decision process. OK, now we see what your needs are. If you want L33 performance and ease of assembly and light wings are important, you need not look further than the Russia AC-4, IMHO. If you do plan on rigging the ship a lot, the desirability of a decent clam shell trailer can not be over-emphasized. Either way, it's good to have a glider of my own. You Bet! Tony V. LS-6b "6N" http://home.comcast.net/~verhulst/SOARING |
#15
|
|||
|
|||
The AC-4 is extremely light and easy to assemble.
And the trailers are tiny compared to the bigger span ships. But the 15 meter ships didn't seem like a huge weight/disassembly step up. Enough to consider it, but my goodness, the gliders less than 10-15 years old seem pretty well set up for disass3embly. The 304c got a few purchasers locally. I haven't had a chance to assemble/disassemble one, though. I'm not a flap guy (I'm a non-flap 'tilter') but there is a cz variant with flaps also, I believe. 150# wings aren't exactly lightweight, though. I really like to help assemble gliders when I can to get a feel for what the wings weigh. I suggest you spend a day at a gliderport 'volunteering.' It seems like a lot of people actually LIKE help putting the wings on or off Good luck! Of course you can always go the other way and get metal, and leave it out in the weather instead... At 22:00 13 July 2005, Jack wrote: Michael wrote: [The L-33 is] all metal...so can be kept assembled and tied down... and...is a pretty sensible ship for...a pilot with low total time who doesn't want to mess with assembling and disassembling after every flight and doesn't have a hangar available. I like the all-metal part, so that I can leave it out for a weekend whenever possible, but the real reason for needing to part with the wonderful 1-26E is that the wings are getting heavier with each passing year, and I can't assemble without a helper or two. This is partially a fault of the open trailer design and partially just me getting older, in addition to the design of the 1-26. I enjoy flying it, and if it unloaded, assembled, disassembled, and loaded as easily as a modern design combination, I'd stick with it indefinitely as the price cannot be beat. It's the most flying fun I've ever had for so little money, and going to any type that did not handle as well in the air would be a disappointment. Another consideration is dues, insurance, storage and operating expenses which will not change much, so the actual cost of a 50 percent performance boost is not huge. However, if I could leave the 1-26 assembled in a hangar I would not consider parting with it for the foreseeable future. ...I recall thinking that your total time was pretty high. If so, and if you must have metal...I would seriously consider one of the HP's instead. Not the hot tip for someone with 50 hours total time...but no big deal at 500 hours. Total time is ~20,000 hrs, the usual military/airline/private stuff; but, my glider time is ~35 hours (2-33 and 1-26), so I am not embarrassed being seen in low performance sailplanes. Hey, I'm still getting used to the idea of flying beyond gliding range of the glider port -- I have done it a few times when conditions were very good. Consideration is also being given to the 1-36 and the PW-5, and the PW-5 is a strong contender. If a ship is easy enough to assemble/disassemb le and has an enclosed trailer, I don't mind putting it together every day of a three-day weekend. I hope to get checked out in the Club's PW-5 this season and that will aid the decision process. Either way, it's good to have a glider of my own. Jack Mark J. Boyd |
#16
|
|||
|
|||
Buy a SparrowHawk !
Should be easy to assemble/disassemble. They're pretty expensive but I'm willing to live vicariously through you ! Doug |
#17
|
|||
|
|||
"it's not really much fun to fly".........
Wow, Hard to believe a knowledgeable glider pilot could express such an opinion about L-33's. Sincerely, David Walsh Michael wrote: Well, there's nothing wrong with the L-33. It's all metal (except for some control surfaces), so can be kept assembled and tied down (I assume this is what made the 1-26E attractive to you). It's quite docile, has reasonable performance for a metal ship, and in general is a pretty sensible ship for a club or a pilot with low total time who doesn't want to mess with assembling and disassembling after every flight and doesn't have a hangar available. The downside is - and this is of course subjective - it's not really much fun to fly. It doesn't have the light touch of the 1-26, or its ability to thermal on a fart. On the other hand, it doesn't really penetrate well either, so it's hard to consider it a serious XC machine. Sure, you can fly XC in it, and people do - but the same is true of the 1-26. I'm not sure the trade is enough of a step up to make the it worthwhile. Also, for some reason I recall thinking that your total time was pretty high. If so, and if you must have metal (I assume for assembled outside storage), I would seriously consider one of the HP's instead. Significantly better performance at less cost and all metal (no fabric) so even better for outside tiedown. Not the hot tip for someone with 50 hours total time (handling is a bit challenging) but no big deal at 500 hours. Michael |
#18
|
|||
|
|||
Doug Snyder wrote:
Buy a SparrowHawk ! Should be easy to assemble/disassemble. They're pretty expensive but I'm willing to live vicariously through you ! I'd be glad to accept donations, and in return mail out a free video of me smiling to each benefactor. Jack |
#19
|
|||
|
|||
Stay with the gteen pickle Jack, but pink?
Rich |
#20
|
|||
|
|||
Total time is ~20,000 hrs, the usual military/airline/private stuff; but, my
glider time is ~35 hours (2-33 and 1-26), so I am not embarrassed being seen in low performance sailplanes. The reason I mentioned total time is this - I don't generally recommend an HP to someone with low total time because the handling is somewhat challenging - more so than is normal for a glider. However, someone with a reasonable amount of airplane time would have no problem with it (and certainly someone with hours in 5 digits including military time would not find the handling challenging). The advantage is this - you get a ship with reasonable XC performance (35:1 and up, depending on model, and much better penetration than you're going to get in any of the other gliders you are considering) in an all-metal ship that can be kept assembled and tied down. It's not really a good choice for a glider-only pilot, because someone with enough experience to deal with the handling usually won't be satisfied with the performance (it won't match a modern glass ship) and a 50-hour pilot is usually going to have problems with the takeoffs and landings (a friend of mine bought his HP-18 at 50 hours and ground looped it at least half a dozen times before he learned to fly it). However, it is a great choice for a transition pilot. I think it would be ideal for you. The 1-26E can be kept tied down outside, but it's not ideal. The control surfaces are fabric, so they will deteriorate. I agree with you about the flying qualities of the 1-26 - it's great fun. I think you will find the L-33 disappointing by comparison; I know I did. It's a shame you don't have a hangar available - the Ka-8 is like a 1-26, only more so - just as light on the controls as the 1-26 but with better feel, and a much better soaring ship. If you ever have the chance to fly one, take it. But it's wood, so outside storage is a problem, and it's just as much of a pain to assemble as the 1-26 if not more so. If you're going to assemble and disassemble daily, I don't really see any advantage to a metal ship. A PW-5 or Russia would make a lot of sense (note - I haven't flown either, so can't comment on the flying qualities) but why not something like a Libelle? I would not recommend an HP if you are going to assemble and disassemble daily - those wings are HEAVY. Michael |
Thread Tools | |
Display Modes | |
|
|