If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
V-12
On 11/22/2011 3:07 AM, Atheist Chaplain wrote:
"Dan" wrote in message ... On 11/21/2011 6:24 PM, Orval Fairbairn wrote: In , "Richard wrote: Next time you're moping around and need a project, try one of these: http://www.wimp.com/tiniestengine/ Rich Isakson I didn't see him installing piston rings, though he had machined grooves for them. What a piece of work! I wish I had the patience to make something like that. CNC would be cheating. Dan, U.S. Air Force, retired 1220 hours used to make that :-) CNCc would cut that drastically but I agree with you, it would be cheating. I'd love to see his plans. Cooling fins on the jugs would have been a nice touch. I cringed when I saw him take the crank shaft to the grinder. Even a well dressed wheel can get messy. Dan, U.S. Air Force, retired |
Thread Tools | |
Display Modes | |
|
|