If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#32
|
|||
|
|||
PowerFlarm Update?
The hex code is part of a Mode S
transponder configuration. Mode A/C transponders don't have a code. The Trig Avionics website has the Installation Manuals where you can read up on Mode S transponder configuration. At 13:46 21 March 2015, Richard wrote: On Saturday, March 21, 2015 at 6:23:23 AM UTC-7, JJ Sinclair wrote: OK, I updated my FLARM to 6.0 and told it my new HEX number (different sa= ilplane), but as far as I can see my my mode a/c transponder doesn't know m= y HEX number...............am I missing something here? How does the FLARM = know to disregard my transponder squalk? JJ JJ, you also need a sentence in the config file to set the kind of xponder. # Set what kind of transponder you have installed: # 0 ... no XPDR (default) # 1 ... Mode C # 2 ... Mode S # configure transponder type $PFLAC,S,XPDR,2 Richard www.craggyaero.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PowerFlarm Update for the Seniors Contest in Florida | Richard[_9_] | Soaring | 24 | February 28th 15 12:32 AM |
Portable PowerFlarm hardware update | kd6veb | Soaring | 8 | March 22nd 13 10:44 PM |
PowerFLARM core external display software update | kirk.stant | Soaring | 5 | January 28th 13 08:56 PM |
PowerFLARM Portable - Firmware Update Available - Mode C Traffic Now Supported | Paul Remde | Soaring | 24 | January 22nd 12 01:50 AM |
PowerFLARM Display Update | Paul Remde | Soaring | 2 | November 11th 10 06:40 PM |