|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 31st 05, 11:18 AM
|
|||
|
|||
Is there a drag rake guru out there?
Can anyone help with the design and installation details of a drag
rake? I'm interested in: Pitot tube sizing ( ID and length ) Span of the rake. Positioning of the dynamic pressure port. Plenum chamber/s dimensions. Positioning of a rake on or behind the trailing edge. Ian 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| max altitude and Mach 1 | Boomer | Military Aviation | 22 | June 1st 04 08:04 PM |
| Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 06:42 PM |
| Source of Induced Drag | Ken Kochanski | Soaring | 2 | January 10th 04 12:18 AM |
| Angle of climb at Vx and glide angle when "overweight": five questions | Koopas Ly | Piloting | 16 | November 29th 03 10:01 PM |
| Did we decide if ballasted pullups are higher???????? | Lars Peder Hansen | Soaring | 22 | October 8th 03 12:45 AM |
Threaded Mode