If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
iPAQ logger problem (no G-record)
Perhaps some knowledgeable person can help me with this. I recently
started using an iPAQ with GPS_LOG WinCE interfaced to a Garmin II. Before flying with it, I did a test run over the hills in my car; it logged the trip perfectly and the log included the G-record. I then flew with it and it logged the complete flight but without the G-record. By viewing the .igc file with a text editor one can see that the G-code was written to the test log but not in the flight log. Perhaps I inadvertently changed a setting or failed to do something that caused it not to write the G-record. I could not find anything in the program's documentation on this subject. Thanks in advance to anyone who can help. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Glider Altitude (Record?) over Mt. Everest | [email protected] | Soaring | 2 | January 19th 06 02:26 PM |
Ipaq - GPS_Log Help needed (Long) | Steve B | Soaring | 1 | September 27th 03 06:00 AM |
iPAQ h2210/h2215 Review | Paul Remde | Soaring | 0 | September 3rd 03 03:45 AM |
Problem: Ground Speed Estimate with Volkslogger and WinPilot | RamyYanetz | Soaring | 3 | August 26th 03 03:06 PM |
iPaq screen viewability | Raphael Warshaw | Soaring | 7 | July 27th 03 06:02 PM |