If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Source of large diameter thick wall tube
This request isn't exactly for an airplane but it's for a glider winch.
I need to find a source for small amounts of 6.5" OD 1" wall steel tube. I don't care too much about the alloy as long as it's reasonably strong and both machinable and weldable. Thanks in advance. Bill Daniels |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
6061-T6 2"x4" rect tube source? | Mr.TwistAir | Home Built | 8 | December 11th 05 04:59 AM |
Boeing Boondoggle | Larry Dighera | Military Aviation | 77 | September 15th 04 02:39 AM |
NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Home Built | 4 | March 16th 04 10:11 PM |
Source for Aluminum Bar 1 Inch thick 4 Inches Wide | Jon Ritter | Home Built | 2 | March 9th 04 01:40 PM |
NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Aviation Marketplace | 0 | March 7th 04 04:06 PM |