If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Refinishing Ventus b Fuselage
On Monday, October 15, 2018 at 10:57:20 PM UTC-7, Ian wrote:
On 2018/10/16 01:54, Richard Pfiffner wrote: Rolled on two coats of Duratec Vinyl ester surfacing primer, sanding tomorrow. Pictures: http://www.craggyaero.com/ventus.htm Nicely documented project. I hope you don't get "arithmetic fatigue" adding up all the hours. Please advise the weight of the fuselage before you started verses that when you finished. Also the moment arm balance for the rudder, before and after. Be kind to the next owner and make sure it is fully documented in the log books. This is always the "unknown" when looking at a refinished glider. I have all the weights before the refinish. Richard www.craggyaero.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 12:15 AM |
refinishing | Stig Pedersen | Soaring | 1 | November 27th 05 04:50 PM |
refinishing | Stig Pedersen | Soaring | 1 | November 26th 05 09:16 PM |
Second speaker in Ventus 2b/c fuselage | [email protected] | Soaring | 3 | September 14th 05 05:41 PM |
REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |