If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Working with plexiglass in winter
I'd like to replace my side windows this winter. Will working with
plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? -- Ben Jackson http://www.ben.com/ |
#2
|
|||
|
|||
Working with plexiglass in winter
"Ben Jackson" wrote in message ... I'd like to replace my side windows this winter. Will working with plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? Depends on the adhesive, read the label. -- Ben Jackson http://www.ben.com/ |
#3
|
|||
|
|||
Working with plexiglass in winter
"Michael Ware" wrote in message news "Ben Jackson" wrote in message ... I'd like to replace my side windows this winter. Will working with plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? Warmth is definately your friend if you are going to drill, sand, trim plexiglass. Trust me I do it for a living. Scott. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Winter Vario | [email protected] | Soaring | 2 | August 17th 05 08:24 AM |
Tie-down winter hazards | [email protected] | Owning | 6 | January 12th 05 10:23 PM |
Winter Flying | [email protected] | Piloting | 36 | January 3rd 05 03:19 AM |
Air Force Working to Combat Stressors | Otis Willie | Military Aviation | 0 | September 18th 04 03:54 AM |
Air Force Museum Working Group to release final report | Otis Willie | Military Aviation | 0 | November 18th 03 12:28 AM |