|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 27th 12, 08:09 PM
posted to rec.aviation.soaring
|
|||
|
|||
Pics/Drawings of Roeger Hook Installation in LS8
My LS8 came with a factory installed Roeger Hook. I removed the receiver side (machined bracket and spring latch) this winter to do some work and put it back in. Now, however, it seems a little "sticky" when opening the canopy. Anyone have a detailed picture of the fuselage showing the receiver in place? The only adjustment options a 1) installing it upside down or 2) tightening or loosening a small cap screw that holds the spring in place. I can't see any way that I could have put it back in wrong, but you never know.
P3 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| needed!! drawings/data for Tost hook for Pawnee | thing73 | Soaring | 3 | November 13th 09 02:14 AM |
| ASW-20B water bag pics/drawings/info wanted | [email protected] | Soaring | 2 | October 13th 08 02:22 PM |
| O-200 installation drawings | rpellicciotti | Home Built | 1 | November 28th 07 06:33 PM |
| Retrofitting Roeger Hook | Chip Bearden | Soaring | 2 | September 20th 07 11:54 PM |
| UH-1 Drawings | JKimmel | Rotorcraft | 5 | November 21st 05 09:03 PM |
Linear Mode
