If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Electrical system considerations
First, I have seen several installations where the ammeter was
connected between the alternator/generator and the main bus. When connected this way, only the total of charge plus load will be shown, and never discharge. Connecting the ammeter between the battery and the bus will show any charge going into the battery over and above the load, and also discharge when the alternator/generator is not supplying sufficient charge. Second, and this applies only if you have a regulator separate from your alternator/generator and you have a circuit breaker between the alternator/generator and the bus. With the regulator connected to the main bus, if the CB from the A/G to the bus were to open for some reason, the regulator, sensing the lower bus voltage without the A/G supplying charging voltage, will supply maximum current to the field. With maximum field current and the high rpm at which we spin our A/G's, its output could rise to 50V-150V depending on rpm and no load. If you were to reset the A/G CB at this time, to could put a substantial voltage/current transient on the bus, which could fry your electronics. This transient could last for the regulator's filter time-constant and the A/G field time constant, which could be many milliseconds. The battery does not supply a good clamp on this transient due to its internal resistance, along with the inductance of the battery to bus leads. Electrically the way you can protect this from happening is to connect the regulator's battery connection to the A/G side of the A/G CB. In this way, even if the A/G CB opens, the regulator is still connected to the A/G output and will maintain a regulated output. Of course, the alternative is never reset the A/G CB with the engine running! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electrical system | Sam Fly | Home Built | 0 | April 1st 04 03:12 AM |
Paint system | Sam Fly | Home Built | 9 | December 2nd 03 12:47 AM |
ALTRAK pitch system flight report | optics student | Home Built | 2 | September 21st 03 11:49 PM |
FA: halon fire ext system for homebuilts | N329DF | Home Built | 0 | August 16th 03 03:12 PM |
2nd update on Review of Plasma II Ignition System | MikeremlaP | Home Built | 8 | July 22nd 03 01:37 AM |