If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Bob Chilcoat wrote ...
Thanks, Daniel, I presume the "t" in the table is thickness? Someone in the RCM group suggested heating the bend line to soften the temper. Anyone here try that? I'll probably experiment a bit before I go to work on the final piece. Hi Bob, Yes, "t" stands for thickness. FWIW, given the nature of the project, I'd just make life easy & calculate the setback and bend allowance based on a 1/8" or greater radius. Wouldn't have to mess with a torch, less risk to the workpiece & a less sharp (safer) corner in the cockpit. Daniel |
#12
|
|||
|
|||
|
|
Thread Tools | |
Display Modes | |
|
|