|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 18th 09, 05:35 AM
posted to rec.aviation.soaring
|
|||
|
|||
Trailer Ramp Jack - NO SCREWS - follow up
To follow up on Uncle Fuzzy's design I modified the ramp on my Pfiefer
tube trailer from the early 80's. Images at: http://picasaweb.google.com/TTaylor07/TrailerJack I used four wheels rather than two for a little more surface area. On real soft ground you could carry two 12"x12" pieces of plywood if needed. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra trailer hydraulic jack refurb? | Frank[_1_] | Soaring | 5 | March 12th 09 11:50 PM |
| Komet Trailer Ramp Jack - NO SCREWS | [email protected] | Soaring | 7 | April 23rd 08 05:39 AM |
| Ramp jack for Komet Trailer | [email protected] | Soaring | 8 | April 2nd 08 05:37 PM |
| Double scissor jack for trailer ramp? | Bullwinkle | Soaring | 15 | January 18th 06 05:18 PM |
| Aluminum Extrusion for trailer ramp (USA) | ttaylor at cc.usu.edu | Soaring | 5 | June 28th 05 04:19 PM |
Threaded Mode