|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 6th 06, 02:08 PM
posted to rec.aviation.owning
|
|||
|
|||
Removing oil galley plug
For those who have installed oil temp probes in the forward oil galley of
their Lycoming engines, how did you or your A&P remove the 1/8" NTP plug? I've got one that is stuck tight and I don't want to booger anything up trying to get it out. I've heard horror stories of people having to drill them out because they are stuck but I'm wondering if an impact driver could be used without causing any damage to the case. Any experience or thoughts would be appreciated. Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fouled plug IO 470 | [email protected] | General Aviation | 7 | January 29th 06 06:03 PM |
| Plug fouled | Denny | Owning | 9 | September 2nd 05 05:58 AM |
| Plug replacements for O-360-A3A | [email protected] | Owning | 3 | August 20th 05 10:39 PM |
| ICOM Headset Adaptor Plug | Ron Wanttaja | Home Built | 3 | June 2nd 05 07:54 AM |
| Helicopter headset plug - help needed | NewsGroups | Home Built | 4 | September 8th 04 05:21 PM |
Threaded Mode