|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 20th 03, 01:14 PM
|
|||
|
|||
air drill question
what rpm range best for aluminum sheet metal? 2600? 3600? less? more?
thanks KM 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
| Tool Question??? | Paul | Home Built | 2 | September 1st 03 04:06 PM |
| Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
| Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 06:03 AM |
| Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 12:18 AM |
Threaded Mode